A furnace that won't light or keeps shutting off needs real diagnosis, not another reset. Every visit includes a carbon monoxide safety check, standard, not an upsell.
A short list of components causes most Furnace Repair calls: ignitor, flame sensor, gas valve, heat exchanger. We test with real equipment, not parts-cannon guessing.
What doesn't change from visit to visit.
A combustion analyzer reading for dangerous CO levels is part of every visit, not optional.
We bump no-heat calls ahead of routine visits when it's cold.
A fixed price is set before repairs start.
Both fuel types get the same trained tech, no exceptions.
Six repairs that cover most of our winter calls.
Cracked ignitors and carbon-fouled sensors cause a large share of no-heat calls, usually a same-visit fix.
We test actual response and pressure output rather than replacing an expensive part on a hunch before we recommend replacing it.
A cracked heat exchanger can leak combustion byproducts into the airflow — we inspect with a scope and analyzer rather than assuming based on age.
Short-cycling or mid-cycle shutdowns often trace to the limit switch or a struggling blower before condemning the control board.
We still service older standing-pilot systems that newer ignition doesn't have.
Zero response from the furnace can mean a wiring fault, not a furnace failure to avoid overcharging for parts you don't need.
Four steps, safety checked at every one.
Tell us what the furnace is doing and we'll get someone moving.
Truck arrives stocked with common ignitor, flame sensor, and control parts ready to diagnose and often repair same visit.
Combustion analysis happens before any repair is quoted, then a flat-rate quote.
We re-check CO before signing off, backed by warranty.
Feedback from completed furnace repairs.
Pilot light kept going out on our older furnace every few days. Tech identified a failing thermocouple that two other companies had overlooked.
— H. Delacroix, homeowner
Furnace made a loud bang on startup that scared the whole family. Turned out to be a delayed ignition issue from a dirty burner, cleaned and resolved same visit.
— F. Ibekwe, homeowner
Called about a gas smell near the furnace closet and they had someone here within the hour to confirm it was safe before doing any repair work.
— Q. Whitmore, homeowner
Landlord here with an older building, they've kept three separate furnace units running through two winters without a single emergency callout.
— Z. Andreou, landlord
Common questions before a Furnace Repair visit.
We always confirm with a proper reading before quoting.
Yes — it can let combustion gases into breathing air, we won't run a confirmed-cracked unit, taken seriously.
A CO check is standard on every call, no upcharge.
We still service these older systems.
No-heat calls get priority routing, usually same-day even during high demand.
Common parts are stocked, rare ones may need next-day ordering to finish the repair.
Our furnace repair coverage spans Columbus and nearby Columbus, KS zips below — call to confirm.
Call +1-844-611-2875
